ACCESSORIES from contacting metal Check the following parts before installation. INSTALLATION DIAGRAM Use the wall hole sleeve Indoor unit (C) to prevent indoor/out- Seal the wall hole door connecting wire (A) gap with putty (H). (120 mm) or more Wall hole cover (D) 1-4. OUTDOOR UNIT water can be avoided asġ4 in. location where continuous direct sunlight or excessive Where it is not exposed to direct sunlight.On a rigid wall to reduce the possibility of vibration.the signal from the wireless remote controller may not be so as to reduce vibration. Where cool air aspreads over the entire room.It is advisable to make a piping loop near outdoor unit.SELECTING THE INSTALLATION LOCATION INDOOR UNIT Note: Note: THE FOLLOWING SHOULD ALWAYS BE OBSERVED FOR SAFETY ġ-2.
Mitsubishi ac split unit manual#
(75 mm) hole saw Vacuum pump for R410A SPLIT-TYPE AIR CONDITIONERS MSY-D30/36NA Torque wrench Charge hose for R410A INSTALLATION MANUAL Wrench (or spanner) Pipe cutter with reamer 1. (4 mm) hexagonal Level wrench Scale Flare tool for R410A MSZ-D30/36NA Utility knife or scissors Gauge manifold for R410A 3 in. Required Tools for Installation JG79A061H01 Phillips screwdriver 5/32 in.